Paint

How much flooring do I need?

Enter the room’s length and width and what one pack covers. The answer comes in whole packs, with the skirting length too.

How it is worked out

Floor area is length times width. Add a margin for the cut at the end of each row, then divide by the area one pack covers, printed on the pack, and round up.

Example: a 13 × 11 ft room is 143 sq ft. With 7% extra that is 153 sq ft. Packs of 20 sq ft: 153 ÷ 20 = 7.65, so 8 packs.

The calculator also gives the perimeter, 2 × (13 + 11) = 48 ft, as a guide for skirting or quarter-round: take off the width of each doorway.

Before you buy

5 to 7% extra is enough for planks laid straight in a rectangular room. Use 10% for a room with alcoves or many doorways, and 15% for a diagonal or herringbone layout.

Let laminate and wood flooring acclimatise: leave the closed packs flat in the room for 48 hours before laying.

Leave an expansion gap of about 3/8 in (10 mm) at every wall; the skirting covers it. A floor laid tight to the wall can buckle when the air gets damp.

Underlay is sold by the roll or the pack; buy it for the floor area without the extra, since it is cut with little waste.

Flooring for common room sizes

Room (ft)Floor areaPacks of 20 sq ftSkirting board
10 × 10100 sq ft640 ft
10 × 12120 sq ft744 ft
12 × 12144 sq ft848 ft
12 × 14168 sq ft952 ft
12 × 16192 sq ft1156 ft
14 × 16224 sq ft1260 ft
16 × 20320 sq ft1872 ft
20 × 20400 sq ft2280 ft

With 7% extra for cuts. Skirting is the full length around the room; take off the doorways.

Worked example: a bedroom with a closet

A 14 × 12 ft bedroom has a closet alcove of 3 × 2 ft: 168 + 6 = 174 sq ft. The alcove and the doorway mean more short cuts, so add 10%: 191.4 sq ft. In packs of 20 sq ft that is 9.6, so 10 packs.

Underlay goes down without the extra: 174 sq ft, two 100 sq ft rolls.

Skirting: the walls are 2 × (14 + 12) = 52 ft round, plus 4 ft for the two sides of the alcove, minus 3 ft for the door: 53 ft. In 8 ft lengths that is 6.6, so 7 lengths; buy an 8th if you have not mitred corners before.

The doorway also needs a threshold or a T-moulding where the new floor meets the hall.

Mistakes to avoid

Laying on an uneven floor: click floors need the subfloor flat, typically within 3/16 in over 10 ft (the pack’s instructions give the figure). Otherwise the joints open or creak.

Short end pieces: plan the first row so the last piece is not a sliver, and keep the end joints of neighbouring rows about 12 in apart, as most instructions ask.

No expansion gap at the door frame: undercut the frame with a saw laid on a spare plank, and slide the floor under it.

Opening packs from one batch only at one end of the room: take planks from three packs at once, so colour and grain mix.

Questions

  • Can I return unopened packs?

    Most stores take unopened packs back, which makes it easy to buy one extra. Check the store’s policy first.

  • Do I measure into the doorways?

    Yes, if the floor runs under the door to a threshold strip. Add a small rectangle for each doorway.

  • What about tiles?

    For ceramic or porcelain tiles, counted one by one, use the tile calculator.